What is the difference between factory-made and site-made furniture?

Precision and consistency. A factory line cuts square to the millimetre and seals every edge; site carpentry depends on the day and the hand, and leaves raw edges that fail in a wet season.

Does factory-made mean standard sizes?

No. Every panel is cut to the drawings you signed off, from walls that were measured and photographed at onboarding — the factory makes your home, not a catalogue.

Far less than building on site: the cutting and finishing have already happened, so fitting is assembly and alignment, checked under ÉLARA 111.

Cut, edged and drilled on a factory line. Fitted in your home, not built in it.

Kitchens, wardrobes and storage are made on a fully automated line — square to the millimetre, sealed on every edge, the same finish on the first panel and the thousandth — and arrive to be fitted, which is what keeps the site clean and the programme short.

Made: On an automated line
Edges: Sealed, every one
On site: Fitted, not built

A craftsman in an olive cap steadies an olive-green panel at the infeed of a modern CNC beam saw in a bright, clean factory hall

What It Means

Factory-Finished Modular Joinery

Modular furniture is cut, edge-banded and drilled on a fully automated factory line, not carpentered on site — square to the millimetre, sealed on every edge, the same finish on the first panel and the thousandth — and fitted in your home rather than built in it.

Why a factory
A beam saw and an edge-bander hold a tolerance no site carpenter can: panels square to the millimetre, edges sealed against moisture, drilling that lines up every time.
The same on the thousandth panel
A finish that is identical from the first shutter to the last, because nothing depends on the day, the weather or the hand.
A quieter, shorter site
Joinery is made while the site is prepared, then fitted — less dust, less noise, and the reason a 60-day handover is possible.
Checked on arrival and once fitted
Under ÉLARA 111, the joinery is checked as it is delivered and again when it is fitted, each check with a photograph, a measurement and a name.

The Standard in full →The 111 checks that keep it →

The Terms

The specifics

Written into the agreement and kept in your app, so there is nothing to remember and nothing to argue.

Carcasses in IS:710 BWP ply and shutters in HDHMR, cut and edge-banded on the line
Hettich or Hafele hardware fitted to factory-drilled positions
Made on a German-standard factory line, to the drawings you signed off
Checked on arrival and after fitting under ÉLARA 111
Covered by the ten-year warranty on joinery

Asked First

The questions this one draws

What is the difference between factory-made and site-made furniture?: Precision and consistency. A factory line cuts square to the millimetre and seals every edge; site carpentry depends on the day and the hand, and leaves raw edges that fail in a wet season.
Does factory-made mean standard sizes?: No. Every panel is cut to the drawings you signed off, from walls that were measured and photographed at onboarding — the factory makes your home, not a catalogue.
Is fitting messy?: Far less than building on site: the cutting and finishing have already happened, so fitting is assembly and alignment, checked under ÉLARA 111.